Aerocon Screw Switch!

The Screw Switch from Aerocon

This little switch is a great  and time tested, highly reliable G resistant switch.  You can use it with a printed circuit board, attach to a piece of G10 or surface mount it to your airframe.  Solder to the leads provided then tighten the screw to close the contacts.

This unusual item consists of a small insulated 5/16" diameter terminal which has 2 solder pins on the bottom and a screw on top.  It had no internal parts to separate in flight due to high G acceleration or deceleration.

$3.50 Each

9 Volt Battery Holder

2 and 4 Position - 3 and 5 Amp

These little terminal blocks give the rocketeers a simple and reliable connection free from the need to solder.  They are available in 2 or 4 terminal blocks and in either 3 or 6 amp.

9 Volt Battery Holder

This sometimes hard to find 9 volt battery holder is exactly the same as the one supplied with the RRC²X. It can be screwed to your electronics sled aiding in securing your power supply into place.

$3.95 each

Terminal Blocks

2 and 4 Position - 3 and 5 Amp

These little terminal blocks give the rocketeers a simple and reliable connection free from the need to solder.  They are available in 2 or 4 terminal blocks and in either 3 or 6 amp.

3 Amp 

Price

2 terminal block

4 - 2 terminal blocks for $1.95

 4 terminal block

2 - 4 terminal blocks for $1.95

 5 amp

Price

 2 terminal block

4 - 2 terminal blocks for $2.25

 4 terminal block

2 - 2 terminal blocks for $2.25